Stone Defender Aerosol Grout Sealer
StoneDefender - Aerosol Grout & Stone Sealer
by EnduraTech Innovations
Material Safety Data Sheet
Expected Wear up to 20 Years
StoneDefender Grout Sealer is a V.O.C. compliant solvent-based sealer that can be applied to damp/uncured grout immediately after installation leaving no hard to remove residue.
It penetrates to protect your grout, stone and masonry surface against oil and water base stains.
Clean treated areas with water and Ph Neutral Cleaner.
DO NOT use harsh or abrasive cleaning agents on treated surfaces.
Expected Wear - up to 20 Years
This will vary depending on type of surface and wear.
Follow the StoneDefender Grout Sealer guide for best results.
This is not a warranty
Always test product in an inconspicuous area to determine suitability for intend use.
Suitability for a particular purpose is always the responsibility for the user.
Use only in well ventilated areas.
Use windows and fans to circulate air
1. Make sure that the surface is thoroughly clean and free from wastes, sealants, or coating of any kind.
2. Apply product evenly. Wipe off excess if spraying vertical areas
3. Allow to cure for 24 hours.
4. Test after application. A second or third coat may be necessary to attain the desired performance. Dries to the touch in abut one hour at 75 f
For both Floor and Wall application
Coverage: 800 – 1000 liner feet of grout per 15 oz .can
Clear coat Max. 1.50
Note: Surface which are not to be sealed must be protected with protective masking material.
Section 1: Chemical Product & Company Identification
Product Name: StoneDefender – Grout & Stone Sealer
Generic Identification: Solvent Base Grout Sealer (Aerosol)
Section 2: Hazardous Components
|Chemical Name||CAS #||Weight %||OSHA PEL TWA||ACGIH PEL TWA||Notes|
|Petroleum Distillate, Odorless Mineral Spirits||64742- 48-9||17 %||200 ppm||200 ppm|
|n-Butyl Acetate||123-86-4||3 %||150 ppm||150 ppm|
|Acetone||67-64-1||47 %||750 ppm||750 ppm|
|Benzene, 1-Chloro-4(Trifluoromethyl)||98-56-6||6 %||Not Established||Not Established|
|Butane||106-97-8||18 %||800 ppm||800 ppm|
|Propane||74-98-6||7 %||1000 ppm||Asphyxiant|
|Proprietary Fluorinated Polymer||Trade
|3-10 %||Not Established||Not Established||This substrate is on the TSCA inventory list.|
Section 3: Physical & Chemical Properties
Boiling Range: -44°F - 315°F
Specific Gravity: 0.72
Freezing Point: n/a
Weight per Gallon: 6.58 #/gal w/out propellant
Evaporation Rate (Butyl Acetate = 1): <1
Vapor Density: Unknown
Percent Volatile: >98 %
VOCs: 3.10 pounds per gallon or 371 grams per liter
Appearance and Odor: Clear, colorless aerosol liquid with a mild citrus odor
Solubility in Water: Insoluble
Section 4: Health Hazards Identification
Eyes: Non-irritating to practically non-irritating
Skin: Slight to moderate irritation, prolonged or repeated exposure can result in defeating and drying of the skin which may result in skin irritation and dermatitis.
Ingestion: May result in vomiting.
Inhalation: High vapor concentrations may result in Central Nervous System (CNS) depression.
Aspiration into lungs must be avoided as even small quantities may result in aspiration pneumonitis.
Carcinogenity: NTP? No IARC Monographs? No OSHA Regulated? No
Section 5: Handling & Storage
Do not store above 120°F/49°C. Do not store or use near heat, sparks or flame.
KEEP OUT OF REACH OF CHILDREN.
Glaze N Seal Wet Look 2000 - Glaze N Seal Wet Look II - Miracle 511 Impregnator Sealer - Glaze N Seal Multi Purpose Sealer - Stone Defender Aerosol Grout Sealer - Glaze n Seal Stone Color Enhancer and Seal
Cleaning and Care links
Anti Slip Links