TAVY Thin-Skin Underlayment System Roll

Price:

$49.95

Qty:

Description

TAVY Thin-Skin Underlayment System - Roll

Two-Part Underlayment

Available Roll or Cut

The TAVY Thin-Skin Two-Part Underlayment System will allow anyone to set tile over any sound surface.

The TAVY Thin-Skin Underlayment is simply trimmed to size and glued to the existing area, using TAVY #007 Glue. Skim-coat the top of the TAVY Thin- Skin Underlayment and you’re ready to set tile

TAVY Thin-Skin Underlayment is a technically engineered non-woven fiberglass reinforced fabric/paper

Tavy Thin-Skin use on:

• Plywood • Lumber • Linoleum • VCT • Vinyl • Cut Back Adhesive Residue • Formica Type Laminates • Sound Painted Surfaces • Porcelain • Plastic • Metal • Fiberglass • Corian • Cultured Marble • Dry Wall • Ceramic Tile • Porcelain Tile • Concrete

Benefit

  • Increase tiling applications by eliminating tear outs of the existing surface
  • Allows for tile or stone to be set on any sound surface
  • Lightweight and easier to transport (less than 15 lbs. per 100 square feet)
  • NO dusty mess to clean up
  • NO additional height added to any surface as opposed to current underlayments
  • NO waste, all TAVY Thin-Skin Underlayment pieces are usable regardless of size and shape
  • 25% - 50% lower cost than other underlayments
  • One roll of TAVY Thin-Skin Underlayment and one gallon of TAVY Thin-Skin #007 Glue will cover 100 square feet
  • Thin-Skin Underlayment is ideal for making templates for difficult cuts
  • No need to buy or install nails/screws
  • Minimize overall load weight
  • Crack suppression up to 1/8" over concrete

5-Step Easy Installation

Step 1: Installer should sweep the sub-surface and make sure that the sub-surface is free from oil, wax, and dust.

Step 2: Apply TAVY Thin-Skin #007 Glue to the sub-surface using a minimum 1/8" v-notched trowel.

Step 3: Install TAVY Thin-Skin Underlayment by unrolling the product into the wet #007 Glue. The Underlayment should be pressed into the #007 Glue with the flat edge of a trowel to remove all air and to ensure the bond between sub-surface and Underlayment.

No cure time is required moving from Step 3 to Step 4

Step 4: Mix a batch of mortar that is the consistency of syrup. This mortar is then used to Skim-Coat the Underlayment. The Skim-Coat is performed with the flat edge of a trowel. This procedure helps key-in the mortar to the Underlayment. The final dried result will be a surface that looks like a rough concrete floor.

Step 5: Start setting tile over the dry Skim-Coated Thin-Skin Underlayment according to industry standards as if you are tiling over any new clean tile-able surface or installed backer board system.

Watch the TAVY Thin-Skin Underlayment System Video

Specifications

  • Model: TAVY8500R

Reviews

Be the first to write a review. Write a Review