Controls and Accessories

The newly-redesigned FloorStat controls are now even more elegant. Loaded with more features, they are easier than ever to install and program due to the new two-part “control face” and “power base” design.
Both FloorStats are sold with power bases as a single item; however, control faces and power bases can be ordered separately, if desired.

Having the thermostat in two parts makes it easier to wire line voltage, the floor sensor and our new remote thermostat control. The control face is easily removed from the power base allowing upgrade from non-programmable to programmable or vice versa. Because a built-in capacitor holds about 2 hours of power, you can also remove the face, program it at the kitchen table, and then reattach it to the power base.

Programmable FloorStat Control

The Programmable FloorStat is both elegant and intelligent. Available for both 120 VAC and 240 VAC, it accepts programming for three set-points: Comfort, Economy (set-back), and Vacation. Features include:
(1) A floor sensor that directly senses floor temperature
(2) A 16-amp capacity controlling up to 150 sq.ft. of 120-VAC, or 260 sq.ft. of 240-VAC WarmWire spaced at 2.5" o.c.
(3) Built-in ground fault protection with no need for a separate GFCI (in most code areas)
(4) Large digital display
(5) Temperature range of 40° to 104°F
(6) Temperature display in °F or °C
(7) On/Off switch
(8) Connection for new Remote FloorStat Control

FloorStat Control

The non-programmable FloorStat is very simple to operate. Just push the on/off button and turn the dial to set the floor temperature. It has several other features:
(1) A floor sensor that directly senses floor temperature
(2) Built-in ground fault protection with no need for a separate GFCI (in most code areas)
(3) Temperature range of 59° to 95°F
(4) 16-amp capacity to control up to 150 sq.ft. of 120-VAC WarmWire spaced at 2.5" o.c.
(5) Connection for new Remote FloorStat Control
Note: Available only in 120 VAC model.

Replacement Control Face and Power Base

Control face units can be ordered separately as non-programmable (500550) or programmable (500650). Replacement
control face units are compatible with either 120-VAC or 240-VAC power base units.
Replacement power bases can be ordered separately. Order either the 120-VAC base (PB112-120GA) or the
240-VAC base (PB112-240GA).

Remote FloorStat Control

This control provides remote control of up to four FloorStats (and possibly other devices). Through a telephone line, you can set the temperature of a thermostat to an energy-saving level during a long absence, and reset it to a comfortable temperature level before returning.
Take advantage of greater operating flexibility and maximize your energy savings. Ideal for primary or secondary residences.

LoudMouth™ Monitor

The LoudMouth sounds an alarm if the wires are cut or damaged, allowing for easy repair before they are covered with mortar and tile.
Use it during the entire WarmWire installation to monitor the heating elements and give yourself the assurance of a quality installation. It’s a must for every job.
Our newly redesigned LoudMouth is better than ever. It has a bright new look and sports several new features:
(1) 9-V battery power (120 VAC before)
(2) A much louder alarm
(3) An on/off switch
(4) Green light to indicate operation and red light to indicate damage
(5) Test button to make sure it’s operational.

Repair Kit

This simple and safe kit repairs heating elements damaged or severed during installation.
Detailed written instructions included.

WarmWire Strap

WarmWire Strap is used to hold WarmWire in place at the desired spacing.
Anchor it at 3'–4' intervals across the floor.
Order one 25' long coil per 40–50 sq.ft. of floor.

Double-sided tape

Coverage area: Apex 150 sq. feet of SunTouch mats installation.

This tape are for use on concrete or hard to nail on floors.

CableTrowel

Non metallic trowel specifically designed for use with electric floor heating systems.

The CableTrowel has been thoroughly tested by professional tile installers.

The CableTrowel 3/8” x3/8 notch size is suitable for larger tile.
The CableTrowel won’t damage the radiant heating wire or your skin.
The CableTrowel Is lighter and easier to use than metal.
The CableTrowel Trowel cleans up quickly, Mortar washes off easily and will never develop rust spot.

Metal trowels can become razor sharp over time and those edge are a danger to electric heating cables.
The CableTrowel blade is made of durable ABS plastic so it’s safer to use around heating elements.
The CableTrowel is lightweight, but tough enough for commercial use.

www.suntouch.com