Glaze N Seal Slate Sealer Fact Sheet

Glaze N Seal Slate Sealer Fact Sheet

Fast Drying Medium Sheen Slate Sealer

Formulated specifically for Slate, Flagstone and Quarry tile

PRODUCT DESCRIPTION

A clear acrylic water base finish designed to protect and beautify slate, flagstone and quarry tile. Glaze ’N Seal Slate Sealer protects against all organic stains including cooking oil, grease and beverages. It may be used indoors or outdoors and is extremely easy to apply and maintain.

USES

  • Water seals, protects and improves appearance of all slate, flagstone and quarry tile.
  • Use indoors and outdoors.
  • Low sheen appearance eases cleanup.
  • May be used as grout release.

FEATURES

  • Repels oil and grease stains
  • Nonflammable
  • No harmful vapors
  • Cleans up with water
  • Easy to apply
  • Water repellent
  • Reduce efflorescence
  • Recoatable
  • Non-yellowing

PREPARATION

All surfaces must be free of efflorescence, dirt, oil, wax, grease and defective paints or sealers. If muriatic acid is used, all acid residues must be removed prior to application of sealer. Do not allow acid to dry. Use Glaze ’N Seal Neutralizing Rinse to neutralize surface before sealing.

STORAGE: Do not allow to freeze.

SPECIFICATIONS

BASE: Aqueous Acrylic Co-Polymer
TUKON HARDNESS: +6.0
FRICTION LEVEL: Excess 6.3
GLASS TRANSITION POINT: 34C
DENSITY: 8.58 pounds per gallon
REFRACTIVE INDEX: Approx. 1.4077
APPEARANCE: Milky White – Dries Clear

APPLICATION

Apply two or more coats of sealer (do not allow it to puddle). Make sure each coat is dry to the touch before applying second coat; usually one to two hours.

Allow additional drying time in moist, cool climates. It can be applied with a sponge mop, lamb’s wool applicator or spray-equipment dependent on porosity and roughness of surface. Clean tools with water before sealer dries. Apply between 55ºF and 80ºF. If it is necessary to apply sealer on a warm day in direct sunlight, slightly dampen the surface to be sealed with a fine spray of water prior to application of the sealer. Allow 72 hours curing time against heavy moisture and bulk water. Sealer will continue to gain strength for up to one week.

Note: Always test a small area of surface to be sealed to verify penetration and satisfaction of sealed appearance.

COVERAGE 100 to 600 square feet per gallon depending on the porosity of the surface.

MAINTENANCE

Glaze ’N Seal Floor Polish is recommended as a protective finish over the sealer (indoors only). This will protect the sealer and extend sealer life significantly. Sweep and damp mop floor frequently. Use Glaze ’N Seal Neutral Cleaner to clean floor as necessary.

Concrete, Tile and Masonry Sealer is packaged in quarts, gallons, 5 gallons and 55 gallon drums.

Buy Now

2 thoughts on “Glaze N Seal Slate Sealer Fact Sheet”

  1. Great beat ! I wish to apprentice while you amend your website, how could i subscribe for a blog website? The account helped me a acceptable deal. I had been a little bit acquainted of this your broadcast offered bright clear concept

  2. Just wanna say thank you for the information. This is exactly the kind of things I was looking around for.

Leave a Reply

Your email address will not be published. Required fields are marked *