Tile-Grip Anti Slip 1 Gallon
Coverage: Quart of Tile-Grip will cover approximately 400 sq. ft. However, working outdoors on windy or sunny days might require more Tile Grip due to a higher evaporation rate..
Tile Grip developed to improve the coefficient of friction on walking areas that are slippery when wet. Materials such as: ceramic tile, marble, quarry tile, terrazzo, stone, porcelain and smooth concrete can now be safer to walk on. Floors can be treated without sandpaper like coatings or concern of discoloration.
Tile Grip is also recommended for porcelain bathtubs and showers. This is an effective treatment that works by creating microscopic pores on the treated surface. These pores create a vacuum effect when wet, therefore improving traction, reducing slippery conditions and preventing injury from slip and falls.
Tile Grip is easy to apply, safe to use, and environment friendly. Its effects are long-lasting but regular cleaning maintenance is required for continued slip resistance.
Tile grip is one step process.
Tile Grip does not discolor tile when applied.
There are little to no odor when treating floors.
Breathing isn't required when it is applied.
Tile Grip is not an abrasive filled product that has to be applied as paint.
Tile Grip does not leave a gritty sandpaper surface on the floor.
Tile Grip is economical and competitively prices.
Tile Grip is Bio degradable.
It is not necessary to wear rubber boots when applying
Tile Grip is Manufacture in the U.S.A
It is not to be used on metals, fiberglass, wood or any resin type products.
It is recommended that very heavy traffic areas be treated annually.
For use with marble
When treating marble be very certain to test it on a small area before treating the entire floor.
Marble is much softer then tile or stone and TILE GRIP has tendency to cure very quick. Cure time can be from 3 to 5 minutes and it’s done, If it cures too fast it can diluted with water.
Start diluted with water. Start to dilute by using 3 parts TILE GRIP to 1 part water. If you find the solution is still too strong add more water to reduce the strength until satisfied with the amount of dilution.
Very Important; Do not allow the solution to dry on the marble. Keep it wet until satisfied with the resistance and rinse immediately with clean water when finished. Do not leave the job without rinsing. Should the marble develop too strong and needs to be diluted.
Click here for more Information
Watch the Video 4:00 min
Why Slip? - treat it with Tile-Grip
FlooringSupplyShop.com feed