PM-DP Snow Sensor Control and Display Panel
The CDP-2 brings control and monitoring of your snow melt system indoors. No need to hope that the system has successfully triggered. One glance at the CDP-2 confirms it! The CDP-2 is compatible with the DS-2B, DS-224, DS-5, and DS-8 rain/snow sensor controllers.
- Convenient Indoor Monitoring and Control
- Self Powered, No AC Wiring or Batteries Required
- Fits Any Standard Single Gang Electrical Box
- Compatible with Leviton Decora®/Hubbell StyleLine™ Cover Plates
- You Choose The Cover Plate Color and Material
- Smart "Manual On" Operates for One Delay Off Cycle
- Home Automation Control Interface
The unit consists of an electronic printed circuit board mounted securely to a steel mounting plate. The overall dimensions of the PM-DP are 4.1"(104) x 1.8"(45) x 0.9"(23). The unit weighs 2.5 ounces. The PM-DP fits into a standard single gang or multi gang electrical enclosure. Compatible self-threading mounting screws that fit both metal and plastic enclosures are included. The plate also has mounting holes for a rectangular "modular" cover plate, similar to the Leviton Decora® or Hubbell StyleLine™ series. This allows the user to select a cover plate color and material that blends with the decor of the room.
Wiring is performed by installing a CS-1 remote control/monitor cable into the companion snow sensor. If not ordered with the sensor this cable may be ordered with the CDP-2. A shielded 5 conductor cable is then installed between the snow sensor and the PM-DP. All signals between the units are very low voltage so no conduit or similar protection of the interconnect cable is required. The individual leads of the interconnect cable are then installed into the rear terminal block of the PM-DP and the unit is ready for operation. The PM-DP does not require batteries or an AC power connection. It is actually powered by parasitic voltage "stolen" from the snow sensor. Peak power consumption is only 3.5 milliwatts. Operational temperature range for the electronic components is -40oC to +85oC
Therefore, the DP-PM can be installed indoors or outside with proper protection from the elements.
Only at flooringsupplyshop.com Lowest Price Guarantee click here for full detail
ProMelt PM-DP Spec & Installation Guide
SunTouch 25 years Warranty
Model: 81012360
