You May Also Like
Modern Stone Revive Grout Cleaner
From: $14.45Description
Modern Stone Revive Grout Cleaner
Available: Gallon, Quart, 5 gal - Concentrated
Professional Results . . . GUARANTEED!
Modern Stone’s Revive is an acid replacement technology cleaner designed to etch grout, remove grout and mortar smears, mineral deposits and rust stains. This concentrated, salts-based cleaner is specially formulated to be highly effective with additional handling and safety benefits when compared to traditional acid-based cleaners.
Revive’s breakthrough formulation is highly resistant against damaging stainless steel, chrome or brass.
Uses: Grout
Revive’s breakthrough formulation is highly resistant against damaging stainless steel, chrome or brass
Application
1. Sweep or vacuum surface to remove loose debris.
*Note: Mask on acid sensitive areas such as stainless steel and natural stone.
2. Dilute Revive with water depending on cleaning task.
* Light cleaning: Mix 1 part with 10 parts water.
* Medium cleaning: Mix 1 part with 6 parts water.
* Heavy cleaning/etching: Mix 1 part with 3 parts water.
3. Apply solution to area and allow to dwell 3-5 minutes. DO NOT allow to dry on surface.
4. Agitate with soft-bristle brush or acid resistant scrubber.
5. Remove dirty solution using a wet/dry vacuum, sponge, or damp mop.
6. Rinse thoroughly with clean water to remove residual cleaner.
7. Dry surface with terry cloth towel or other absorbent materia
Covers Approximately 1000 to 10,000 sq. ft per gallon.
Handling and Storage
Close container after each use. Store in original container only. Keep in a dry, well-ventilated area. Avoid freezing or long-term high temperature storage.
Caution:
PROTECT AREAS FROM OVERSPRAY. Rubber gloves and eye protection should be worn during
application. Avoid contact with eyes and skin. Immediately flush eyes with water for 15 minutes. If skin contact occurs wash with soap and water. Do not take internally. Do not induce vomiting. Seek medical attention
Use on acid-resistant tile, stone or masonry surfaces. A pre-test for resistance should be performed prior to use. Test in an inconspicuous area to determine ease of application and desired results. Warning: This product is not for use on natural stone surfaces such as flagstone, marble or limestone. If revive is sprayed or splashed on stainless steel, chrome or brass, simply rinse cleaner off metal with water.
Modern Stone Product Coverage Chart